Cost to pour a concrete slab in Houston: the short answer
projectcosted builds its Houston figure from Bureau of Labor Statistics wage data and lands at $5.62 to $11.24 per square foot installed, about 2% above the Texas average of $5.54 to $11.07. Its published sizes and our computed rows at the same rate:
| Size | Installed range | Typical |
|---|---|---|
| 10x10 (100 sq ft) | $562 to $1,124 | $843 |
| 12x12 (144 sq ft) | $809 to $1,619 (computed) | n/a |
| 20x20 (400 sq ft) | $2,247 to $4,495 | $3,371 |
| 24x24 (576 sq ft) | $3,237 to $6,474 (computed) | n/a |
| 25x40 (1,000 sq ft) | $5,619 to $11,237 | $8,428 |
| 30x40 (1,200 sq ft) | $6,744 to $13,488 (computed) | n/a |
| 40x60 (2,400 sq ft) | $13,488 to $26,976 (computed) | n/a |
projectcosted.com, Houston TX, updated August 23, 2026. Rows marked computed multiply the area by $5.62 to $11.24 per sq ft; the others are as published. A wage-model estimate, not a contractor quote.
For a fast estimate on any size, the Houston concrete slab calculator does the cubic yards and the price range together.

Houston slab and pad prices by type of job
A second Houston guide prices slabs by what they are for. The spread is the point: a house foundation costs roughly twice what a patio does per square foot because of beams, plumbing and engineering.
| Job | Per sq ft | 500 sq ft at that rate (computed) |
|---|---|---|
| Patio slab | $6 to $11 | $3,000 to $5,500 |
| Garage floor | $6 to $11 | $3,000 to $5,500 |
| Driveway | $6 to $14 | $3,000 to $7,000 |
| Shed or storage pad | $8 to $11 | $4,000 to $5,500 |
| Pool deck | $11 to $16 | $5,500 to $8,000 |
| Home foundation | $10 to $18 | $5,000 to $9,000 |
constructlytools.com Houston cost guide, last reviewed May 16, 2026. The third column multiplies each range by 500 sq ft for comparison only.
Concrete pad cost
People price “a concrete pad” and “a concrete slab” as if they were different things; the difference is mostly size. Small pads cost more per square foot because the setup, forming and finishing are spread over less concrete. That is why shed pads sit at $8 to $11 while a big patio can come in near $6. The concrete pad installation page covers AC, generator and equipment pads in detail.
Where the money goes on a 400 sq ft Houston slab
projectcosted splits its typical 400 sq ft Houston slab into four parts. Applied to its $3,371 typical price:
| Part | Share | Of $3,371 (computed) |
|---|---|---|
| Labor | 50% | $1,686 |
| Materials (concrete, steel, base, forms) | 36% | $1,214 |
| Site prep and equipment | 8% | $270 |
| Overhead, disposal and finishing | 6% | $202 |
Shares from projectcosted.com Houston TX, August 23, 2026. Dollar column computed; rounding moves it by a dollar.
Half the bill is labor, and Houston labor runs higher than the state: projectcosted uses $27.41 an hour locally against $26.54 for Texas. Concrete itself is a smaller line than most people expect. A 20x20 slab 4 inches thick holds about 4.94 cubic yards; at constructlytools' $125 to $160 per delivered yard that is roughly $617 to $790 of ready-mix before any waste allowance.
Houston add-ons: clay, humidity and site prep
The constructlytools guide names Houston's expansive Beaumont clay and its humidity and heat as cost factors and prices the usual responses:
| Add-on | Added cost | Why it comes up |
|---|---|---|
| Thicker slab, 5 to 6 in instead of 4 | +$1.00 to $2.50 per sq ft | Stiffer section over expansive clay |
| Rebar upgrade | +$0.75 to $1.50 per sq ft | More steel to hold cracks tight |
| Curing compound | +$0.15 to $0.30 per sq ft | Slows moisture loss in heat and wind |
| Site prep overhead | +$0.50 to $1.50 per sq ft | Grading, drainage, removing wet or soft soil |
constructlytools.com Houston cost guide, May 16, 2026.
Two Houston costs no calculator site lists. Water: the USDA's Beaumont series describes a poorly drained clay that stays saturated deep in the profile, so a wet site may need pumping, drying time or soft soil cut out and replaced before forms go down. And height: a new building slab inside the City has to sit 12 inches above the nearest sewer manhole rim, and in a floodplain at the 500-year elevation plus 2 feet, which can mean truckloads of fill (see the floodplain elevation guide). Rain days push schedules too; the humidity and rain guide explains why.

Permit costs
Plenty of Houston slabs need no permit at all: driveway and sidewalk flatwork inside the impervious-area limit, and accessory buildings of 120 sq ft or less, are exempt under the City's code. constructlytools estimates $150 to $400 for a typical residential slab permit. Treat that as a placeholder from a pricing guide, not a City fee, and check the Houston slab permit guide to see whether yours needs one.
How to read a Houston slab quote
- Thickness and steel stated (rebar size and spacing, or mesh), not just 'reinforced'
- Base material and depth, and whether soft or wet soil removal is included
- Vapor retarder: included or not, and why
- Control joint layout and when the joints get cut
- Finish (broom, smooth trowel) and curing method
- Who hauls off spoils and any old concrete, and who pulls any permit
- What happens to the schedule and the price if it rains on pour day
Replacing an old, broken slab rather than pouring on open ground? The level or replace guide compares what leveling costs against a new pour.

